Single Board Computer OK1061-S based on NXP i.MX RT1061
OK1061-S is a single board computer designed based on NXP Cortex-M7 MCU i.MX RT1061@ 528MHz(commercial grade one 600MHz), has on-chip SRAM up to 1MB, 512KB can be flexibly configured as TCM or general purpoes on-chip RAM, and it can support QSPI-NOR Flash with capability of 4MB.
It consists of i.MX RT1061 SoM with compact volume of 30x 30x 3mm and carrier board with dimensions of 104x 80mm, and SoM soldered on carrier board. It integrates HS_GPIO, CAN-FD and NAND/ NOR/ PSRAM controllers. The SoM temp width ranges from -40℃ to +85℃. Meanwhile, various peripheral interface such as UART, 2x Ethernet, USB, CAN, CAN-FD, HS_GPIO and PWM, ADC are available on carrier board. Bare metal and Free RTOS are both supported.
On-Chip SRAM
Up to 1MB on-chip SRAM, perfect compatibility with i.MX RT1052 pin-to-pin
CAN Bus
CAB-FD and CAN2.0B are both available
HS-GPIO available for flexible protocols
Up to 32 bits of I/O are available and is capable of supporting
a wide range of protocols in cluding, but not limited to: UART, I2C, SPI, PWM, etc.
Communication Interface
SoM is available with dual channels of 10M/100M Ethernet, CAN2.0B and 7-ch UART
Native data encryption
NXP-MCUBootUtility is a special tool for NXP MCU booting security and encryption solution which is a real one-stop and full GUI tool supports full range of i.MX RT MCU
Industrial grade quality
Designing with full consideration of signal integrity to
ensure optimized electrical; optimized power structureand regulated power sequence to enhance Robustness.
OK1061-S Single Board Computer
▊ Hardware Features
Overview of FET1061-S System on Module | |
---|---|
CPU | i.MXRT1061 |
Architecture | Cortex-M7 |
Frequency | 528MHz |
RAM | On Chip SRAM 1MB |
Flash | QSPI Nor Flash 4MB (16MB QSPI Nor Flash) |
OS | bare metal, FreeRTOS, RT-Thread |
Power In | 5V |
Dimensions | 30×30mm |
PCB | thickness: 1mm, 4-layer ENIG |
Package | edge soldering, 4*25pin, pitch of 1mm |
Working Temperature | -40℃~+85℃ |
FET1061-S System on Module Features | ||
---|---|---|
Interface | QTY | Spec. |
SD/MMC/SDIO | ≤2 |
Supports SD/ SDIO card 1-bit or 4-bit transfer modes |
USB | 2 |
USB2.0(up to 480Mbps), integrated with HS USB PHY |
SAI | ≤2 |
Up to 3-ch I2S audio |
UART | ≤7 |
Each up to 5.0Mbps |
eCSPI | ≤3 |
Full duplex enhanced serial interface, data rate up to 52Mbit/s. It's available for both host and slave modes, each SPI controller has four chip selection to support multiple prepherial |
IIC | ≤4 | |
Ethernet | ≤2 |
10/ 100Mbps auto-negotiation |
PWM | ≤26 |
4x 16-bit PWM controller, each channel support up to 8 pins |
SWD | supported | |
KeyPad Port | supported | 8*8; |
QSPI | ≤2 | QSPI NOR flash |
CAN | ≤2 | CAN 2.0B |
CAN FD | 1 | CAN FD |
ADC | ≤20 |
two 12-bit ADC, up to 20 input channel |
OK1061-S Carrier Board Features | ||
---|---|---|
Interface | QTY | Spec. |
CAMERA | 1 |
8-bit CSI, up to 5.0MP(available for RT1052/ RT1062) |
Audio | 1 | 1*MIC, 1*Phone |
USB Host | 1 |
USB2.0(up to 480Mbps) |
USB OTG | 1 |
standard micro USB connector, USB2.0(up to 480Mbps) |
Ethernet | 2 |
10M/ 100Mbps, RJ45 |
RTC | 1 | RX8010SJ, CR1220 |
EEPROM | 1 |
24C02, 256bytes |
TF Card | 1 |
compatible with SD, SDHC |
LED | 2 |
for users |
POR_BUTTON | 1 | reset |
WAKEUP | 1 |
wake up key |
ON/OFF | 1 |
power switch, keep pressing to switch on or off |
BOOT | 1 |
DIP switch, for booting mode options, presently only available for internal TF, QSPI NOR Flash booting mode |
PWM | 1 |
headers with pitch of 2.54mm |
ADC | 1 |
multiplexed with CAN, jumper cap turnt to left(21, 22) to choose ADC mode |
IIC | 1 |
Camera, WM8960, EEPROM, RTC, IIC address not conflict by default, and could be used together |
CAN | 1 |
CAN2.0B, DG128-2P connector, multiplexed with ADC, P14 turnt to right(22, 23) to choose CAN TX |
CAN FD | 1 |
CAN FD, multiplexed with CAN2, DG128-2P connector |
SPI | 1 |
10P header with pitch of 2.0mm, multiplexed with TF card |
UART | 1 |
3-wire serial, 3.3V, each up to 5.0Mbps, 10P header with pitch of 2.54mm |
I2S | 1 | WM8960 |
UART Debug | 1 |
RS232, DB9 connector |
SWD | 1 |
debug port, P13, 4P header with pitch of 2.54mm |
KEY BOARD | 1 | 4×4 keyboard, multi-plexed with camera, drawn out by a 10-pin header with pitch of 2.54MM(8Pins for keyboard). |
▊ Software Features
DEMO | |
---|---|
Demos under \boards\evkbimxrt1060\driver_examples | Demos under \boards\evkbimxrt1060\demo_apps |
ADC | helloword |
adc_etc | hello_world_virtual_com |
bee | led_blinky |
cache | power_mode_switch |
cmp | sai |
dcp | shell |
edma | uart_gprs |
enc | xbar_aoi |
enet | Demos under \boards\evkmimxrt1060\lwip_examples |
canfd | lwip_httpsrv |
flexcan | lwip_iperf |
flexio | lwip_ping:ping |
flexio3 | lwip_ping_enet1_enet2: Dual network ports ping |
flexram | lwip_tcpecho |
flexspi: read and write Flash | lwip_tcpecho_enet1_enet2 |
gpio: LED | lwip_udpecho |
gpt | lwip_udpecho_enet1_enet2 |
kpp | Demos under \boards\evkmimxrt1060\rtos_examples |
lpi2c: (RTC, EEPROM) | freertos_event |
lpspi | freertos_generic |
lpuart (uart2) | freertos_hello |
pit | freertos_lpi2c_eeprom |
flexpwm | freertos_lpuart |
qtmr | freertos_mutex |
rtwdog | freertos_queue |
sai | freertos_sem |
sdcard | freertos_sem_static |
snvs | freertos_swtimer |
src | freertos_tickless |
tempmon | Demos under \boards\evkmimxrt1060\usb_examples |
trng | usb_device_hid_mouse |
wdog | usb_host_hid_mouse |
ewm | usb_host_hid_mouse_keyboard |
xbara | |
Demos under boards\evkmimxrt1060\fatfs_examples | fatfs_sdcard |
▊ Download
Catalog: Forlinx Catalog Manual
Product Brief: FET1061-S SoM and OK1061-S SBC introduction
▊ Accessories
Please click here to get more information about the supported modules and accessories.
▊ Technical Support
1. Files to be provided after buying
Hardware related: datasheet, user guide, carrier board schematic, carrier board PCB, SoM pinmux;
Firmware related: OS image, testing demo, source code, manual;
Compiling environment
2. Fast response after-sale technical support service
Contact Us
Welcome to get in touch with us, our experts will reply to your email within 24 hours.
▊ How To Buy
1. Order Online
We have an online store on Alibaba, please contact us for details.
2. Order Offline
Please send your inquiry to [email protected];
3. Payment Terms
100% T/T in advance.
▊ Shipment
1. Delivery: Goods will be shipped by express upon the receipt of the payment;
2. Lead time: Goods will be shipped out within five working days for sample orders and 6 weeks for bulk orders;
3. Shipping charge: Buyers should bear the shipping cost.
▊ Other Forlinx iMXRT Series Products
Architecture: Cortex-M7
Frequency: 528MHz
RAM: 1MB on-chip SRAM
ROM: 4MB QSPI NorFlash(16MB optional)
System: FreeRTOS,RT-Therad,Bare Metal
Architecture: Cortex-M7
Frequency: 528MHz
RAM: 512KB SRAM ,16MB SDRAM,32MB SDRAM(optional)
ROM: 4MB QSPI NorFlash(16MB optional)
System: UcLinux,FreeRTOS,RT-Therad,Bare Metal
Architecture: Cortex-M7
Frequency: 528MHz
RAM: 512KB SRAM ,16MB SDRAM,32MB SDRAM(optional)
ROM: 4MB QSPI NorFlash(16MB optional)
System: UcLinux,FreeRTOS,RT-Therad,Bare Metal